Specifications

DES-1228/ME Layer 2 Metro Ethernet Switch CLI Reference Manual
215
delete authen server_host
 tacacs+
− Enter this parameter if the server host utilizes the TACACS+ protocol.
 radius − Enter this parameter if the server host utilizes the RADIUS protocol.
Restrictions Only Administrator-level users can issue this command.
Example usage:
To delete a user-defined TACACS+ authentication server host:
DES-1228/ME:4#delete authen server_host 10.1.1.121 protocol tacacs+
Command: delete authen server_host 10.1.1.121 protocol tacacs+
Success.
DES-1228/ME:4#
show authen server_host
Purpose Used to view a user-defined authentication server host.
Syntax
show authen server_host
Description This command is used to view user-defined authentication server hosts previously created
on the Switch.
The following parameters are displayed:
IP Address – The IP address of the authentication server host.
Protocol – The protocol used by the server host. Possible results will include TACACS,
XTACACS, TACACS+ or RADIUS.
Port – The virtual port number on the server host. The default value is 49.
Timeout − The time in seconds the Switch will wait for the server host to reply to an
authentication request.
Retransmit − The value in the retransmit field denotes how many times the device will
resend an authentication request when the TACACS server does not respond. This field is
inoperable for the tacacs+ protocol.
Key − Authentication key to be shared with a configured TACACS+ server only.
Parameters None.
Restrictions None.
Example usage:
To view authentication server hosts currently set on the Switch:
DES-1228/ME:4#show authen server_host
Command: show authen server_host
IP Address Protocol Port Timeout Retransmit Key
------------ -------- ----- ------- ---------- -------------
10.53.13.94 TACACS 49 5 2 No Use
Total Entries : 1
DES-1228/ME:4#
create authen server_group
Purpose Used to create a user-defined authentication server group.