Specifications

DES-1228/ME Layer 2 Metro Ethernet Switch CLI Reference Manual
33
Command Parameters
create trusted_host <ipaddr>| network<network_address>
delete trusted_host [all | ipaddr<ipaddr>| network<network_address>]
show trusted_host
enable snmp traps
enable snmp authenticate traps
config stp trap {new_root [enable|disable]|topo_change [enable|disable]}(1)
show snmp traps {linkchange_traps { ports <portlist>}}
disable snmp traps
disable snmp authenticate traps
config snmp system_contact <sw_contact>
config snmp system_location <sw_location>
config snmp system_name <sw_name>
enable rmon
disable rmon
config snmp linkchange_traps ports [all|<portlist>] [enable|disable]
enable snmp linkchange_traps
disable snmp linkchange_traps
config snmp coldstart_traps [enable|disable]
config snmp warmstart_traps [enable|disable]
Each command is listed, in detail, in the following sections.
create snmp user
Purpose Used to create a new SNMP user and adds the user to an SNMP group that is also
created by this command.
Syntax
create snmp user <SNMP_name 32> <groupname 32> {encrypted [by_password
auth [md5 <auth_password 8-16> | sha <auth_password 8-20>] priv [none | des
<priv_password 8-16>] | by_key auth [md5 <auth_key 32-32> | sha <auth_key 40-
40>] priv [none | des <priv_key 32-32>]]}
Description
The create snmp user command creates a new SNMP user and adds the user to an
SNMP group that is also created by this command. SNMP ensures:
Message integrity − Ensures that packets have not been tampered with during transit.
Authentication − Determines if an SNMP message is from a valid source.
Encryption − Scrambles the contents of messages to prevent it from being viewed by an
unauthorized source.
Parameters
<SNMP_name 32> − An alphanumeric name of up to 32 characters that will identify the
new SNMP user.
<groupname 32> − An alphanumeric name of up to 32 characters that will identify the
SNMP group the new SNMP user will be associated with.
encrypted – Allows the user to choose a type of authorization for authentication using
SNMP. The user may choose:
by_password – Requires the SNMP user to enter a password for authentication and
privacy. The password is defined by specifying the auth_password below. This
method is recommended.
by_key – Requires the SNMP user to enter an encryption key for authentication and
privacy. The key is defined by specifying the key in hex form below. This method