Specifications

DES-1228/ME Layer 2 Metro Ethernet Switch CLI Reference Manual
57
show config
Purpose Used to display the current or saved version of the configuration settings of the switch.
Syntax
show config [ current_config {[include | exclude | begin] <filter_string 80>
{<filter_string 80> {<filter_string 80>}} {[include | exclude | begin] <filter_string 80>
{<filter_string 80> {<filter_string 80>}} {[include | exclude | begin] <filter_string 80>
{<filter_string 80> {<filter_string 80>}}}}} | config_in_nvram <config_id 1-2> {[include
| exclude | begin] <filter_string 80> {<filter_string 80>{<filter_string 80>}} {[include |
exclude | begin] <filter_string 80> {<filter_string 80> {<filter_string 80>}} {[include |
exclude | begin] <filter_string 80>{<filter_string 80> {<filter_string 80>}}}}} |
information ]
Description Use this command to display all the configuration settings that are saved to NV RAM or
display the configuration settings as they are currently configured. Use the keyboard to list
settings one line at a time (Enter), one page at a time (Space) or view all (a).
The configuration settings are listed by category in the following order:
• Basic (serial port, Telnet and web
management status)
• storm control
• IP group management
• Syslog
• QoS
• port mirroring
• traffic segmentation
• port
• port lock
• 8021x
• SNMPv3
• management (SNMP traps
RMON)
• VLAN
• FDB (forwarding data base)
• MAC address table notification
• STP
• SSH
• ACL
• SNTP
• IP route
• LACP
• ARP
• IP
• IGMP snooping
• access authentication control (TACACS
etc.)
• Bandwidth
• safeguard_engine
• Banner_promp
• SMTP
• AAA
• DHCP_Relay
Parameters
current_config – Entering this parameter will display configurations entered without being
saved to NVRAM.
config_in_NVRAM − Entering this parameter will display configurations entered and saved
to NVRAM.
Restrictions Only Administrator-level users can issue this command.