User`s guide

Gigabit Ethernet Switch User’s Guide
57
Figure 6-44. Update Firmware and Configuration Files screen
The fields you can set are:
♦ Software Update Mode
Set to either
Network
or
SLIP
. Determines whether the configuration file
should be obtained through the Ethernet network or through the console port.
♦ TFTP Server Address
The IP address of the TFTP server where the configuration file is located. This
entry is used only if the Firmware Update is set to
Enabled
. If BOOTP Service (see the IP Configuration
screen under Configure IP Address on the System Configuration menu) is set to
Enabled
, the address
will be obtained from the BOOTP server.
♦ Firmware Update
Determines whether or not the Switch will try to look for a runtime image file over
the network. If set to
Disabled
, none of the fields below have any effect.
♦ File Name
The pathname of the runtime image file on your TFTP server to be downloaded.
♦ Use Config File
Toggle to
Enabled
to download config file during reboot.
♦ File Name
The name of the configuration file to be downloaded.
System Utilities
The
Utilities
menu features
Ping Test
,
Save Settings to TFTP Server
,
Save Switch History to TFTP
Server
, and
Clear Address Table
commands. Additionally, this menu allows you to enable or disable Web
management.
Choose
System Utilities
on the main menu to access the
Utilities
menu seen below: