Specifications

2
4. The RS-232 connection to the computer should be
configured as follows:
§ Baud rate = 9600
§ Parity = none
§ Data bits = 8
§ Stop bits = 1
§ Flow control = none
Make sure the terminal or computer you are using to make
this connection is configured to match these settings.
With the serial port properly connected to a management
computer, the following screen should be visible. If this screen
does not appear, try pressing Ctrl+r to refresh the console
screen.
Each DES-7003 CPU management module is assigned a
unique MAC address by the factory. This MAC address cannot
be changed, and can be found from the initial boot console
screen – shown below.
Figure 1- 1. Boot Screen
The MAC address of the CPU module can also be viewed by
requesting a list of basic information about the switch (see
show switch command in Chapter 4).