Specifications

168
Note: Date and time CLI commands must be accessed from a subdirectory
within the main system command directory. To access the subdirectory
named “systemtime” type systemtime at the CLI command prompt and
press the Enter key. This will allow you to use the CLI commands in this
directory. It will also change the CLI command prompt (see the example
below).
The save command can be used within the systemtime subdirectory so it is
not necessary to return to the main directory to save the date and time
settings.
To exit the systemtime subdirectory, type two periods “..” and press Enter.
systemtime
Purpose Used to access CLI commands in
subdirectory systemtime.
Syntax systemtime
Description Use this to change the current directory to
the subdirectory systemtime in order to
config date and time settings or to
configure SNTP settings.
Parameters None.
Restrictions None.
To access CLI commands located in the systemtime
subdirectory:
DES-7100:4#systemtime
Command: systemtime
DES-7100:4/systemtime#