Specifications

43
Command Parameters
Show
vdsl_port_rate_adaptive
Each command is listed, in detail, in the following sections.
Note: Commands that use a <portlist> parameter allow you to specify a sequential
range of ports or a single port on the switch. The port list is specified by listing the
lowest slot number and the beginning port number on that slot, separated by a
colon. Then highest slot number, and the highest port number of the range (also
separeted by a colon) are specified. The beginning and end of the port list range
are seperated by a dash. For example, 6:1 would specify module in slot number 6,
port 1. 7:24 specifies module in slot number 7, port 24. 6:1 -7:24 specifies all of
the ports between module 6, port 1 and module 7, port 24 − in numerical order. For
a single port, just enter the slot number and port number separated by a colon.
config ports
Purpose Used to configure the switch’s Ethernet port
settings. For VDSL ports on the DES-7010
switch module, use the config_vdsl_ports
command. Ports on the DES-7006 switch
module have a fixed speed and duplex (100
Mbps Full) and therefore these can not be
configured.
Syntax config ports [<portlist>] {speed
[auto/10_half/10_full/100_half/100_half/
1000_half/1000_full]
flow_control [enabled/disabled]
learning [enabled/disabled]
state [enabled/disabled]}
Description This command allows for the configuration of
the switch’s Ethernet ports. Only the ports
listed in the <portlist> will be affected.