Specifications

44
config ports
Parameters
portlist − specifies a range of ports to be
configured.
auto − enables auto-negotiation for the
specified range of ports.
[10/100/1000] − configures the speed in Mbps
for the specified range of ports. Gigabit ports
are statically set to 1000 and cannot be set to
slower speeds.
[half/full] − configures the specified range of
ports as either full- or half-duplex.
Flow_control [enable/disable] − enables or
disables flow control for the specified range of
ports.
learning [enable/disable] − enables or disables
the MAC address learning on the specified range
of ports.
state [enable/disable] − enables or disables the
specified range of ports.
Restrictions Only administrator-level users can issue this
command.
Example Usage:
To configure the speed of the ports 1-24 of module 3 to be 100
Mbps, full-duplex, learning and state enabled:
DES7000:4@#config ports 3:1-3:24 speed
100_full
learning on state enable
Command: config ports 3:1-3:24 speed
100_full
learning on state enable
Success.