j/3
FCC Warning This equipment has been tested and found to comply with the regulations for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with this user’s guide, may cause harmful interference to radio communications.
Table of Contents D-Link Web Smart Switch User Manual Table of Contents Table of Contents ............................................................................................................................................. i About This Guide............................................................................................................................................. 2 Terms/Usage.........................................................................................................
About This Guide D-Link Web Smart Switch User Manual About This Guide This guide provides instructions to install the D-Link 8-port Gigabit Ethernet PoE Switch DGS-1008P. Terms/Usage In this guide, the term “Switch” (first letter capitalized) refers to the DGS-1008P, and “switch” (first letter lower case) refers to other Ethernet switches. Some technologies refer to terms “switch”, “bridge” and “switching hubs” interchangeably, and both are commonly accepted for Ethernet switches.
1 Product Introduction 1 D-Link Web Smart Switch User Manual Product Introduction The DGS-1008P Switch provides 8 Gigabit Ethernet ports, of which 4 ports supporting Power over Ethernet (PoE) for PoE applications such as wireless Access Points (APs), IP cameras, and IP phones, and the other 4 ports without PoE for computers, printers and Network Attached Storage (NAS) onto a network. With wirespeed Gigabit capacity, DGS-1008P provides non-blocking switching for both home and office environment.
1 Product Introduction D-Link Web Smart Switch User Manual Port Link/Act/Speed LED (1-8): The Port LED indicates the link status of corresponding ports. Blinking indicates that the Switch is either sending or receiving data to the port. When the port LED glows in amber, it indicates that the port is running on 10M or 100M. When the port LED glows in green, it is running on 1000Mbps. Rear Panel Figure 2 – DGS-1008P Rear Panel DC Power Jack: Connect to the power adapter.
2 Hardware Installation 2 D-Link Web Smart Switch User Manual Hardware Installation This chapter provides unpacking and installation information for the D-Link DGS-1008P. Step 1: Unpacking Open the shipping carton and carefully unpack the contents. Please consult the packing list located in the User Manual to make sure all items are present and undamaged.
3 Understanding The Switch Features 3 D-Link Web Smart Switch User Manual Understanding The Switch Features Cable Diagnostics DGS-1008P will scan all ports when device booting up. The diagnosis results will be displayed by port LED at the first 1 second after port scan finished. And following are the explanation of the result: Solid Green: A Gigabit connection is detected and the cable is good. Solid Amber: No connection, bad cable or 10/100M connection is detected.
3 Understanding The Switch Features D-Link Web Smart Switch User Manual Power Saving by Link Status: Drastically save power when the switch port link is down. For example, when there are no PC connections or the connected PC is powered off. Power Saving by Cable Length: Detects the length of connected RJ-45 cables and adjusts power usage accordingly without affecting performance.
Appendix A - Technical Specifications D-Link Web Smart Switch User Manual Appendix A - Technical Specifications Total PoE budget: 52 watts, average 13 watts per PoE port. Hardware Specifications Key Components / Performance Switching Capacity: 16Gbps Max. Forwarding Rate: 11.90Mpps Forwarding Mode: Store and Forward Packet Buffer memory: 192K Bytes Port Functions 8 10/100/1000Base-T ports compliant with the following standards: - IEEE 802.3 - IEEE 802.3u - IEEE 802.
