Installation guide

DGS-1510 Series Gigabit Ethernet SmartPro Switch Hardware Installation Guide

DDM), 20km, TX: 1270nm, RX: 1330nm)

• DEM-436XT-BXD (10GBASE-LR BiDi SFP+ Transceiver (w/o

DDM), 20km, TX: 1330nm, RX: 1270nm)

SFP+ Direct Attached Cables (DAC) Supported:

• DEM-CB100S-10-GbE (SFP+, 1m, Direct Attach Cable), for

stacking.

• DEM-CB300S-10-GbE (SFP+, 3m Direct Attach Cable), for

stacking.

• DEM-CB700S-10-GbE (SFP+, 7m Direct Attach Cable), for

stacking.

PoE Ports

(DGS-1510-28P Only)

1. Supports IEEE 802.3af PoE and IEEE 802.3at PoE+

compliance.

2. Supplies power (ports 1 to 24) to PD devices up to 15.4 Watt

per

port (802.3af) or 30 Watt per port (802.3at) and more sufficiently

is able to provide power to PD devices.

3. The auto-discovery feature automatically recognizes the

connection of the PD device and immediately provides power.

4. Automatically disable ports if the port current is over 600mA

while. Other ports will remain active.

5. Active circuit protection automatically disables the port if there is

a short while other ports remain active.

6. For 802.3af/at capable devices it will provide the power for the

following classifications below:

Class Usage Max Power used by PD

0 Default 0.44 Watt to 12.95 Watt

1 Optional 0.44 Watt to 3.84 Watt

2 Optional 3.84 Watt to 6.49 Watt

3 Optional 6.49 Watt to 12.95 Watt

4 Optional (802.3at

Only)

12.95 Watt to 25.5 Watt

7. Follow the PSE pin out standard. For an alternative solution,

send the power over pins 1, 2, 3, 6 and 8 wires. Use Category 3,

6A UTP cable for 802.3af or Category 5e, 6A UTP cable for

802.3at.

8. The DGS-1510-28P works with all D-Link 802.3af and 802.3at

capable devices and with all non-802.3af and non-802.3at

capable D-Link Access Points, IP Cameras and IP Phones.

9. The total power budget is 193 Watts.