Owners manual

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
182
Command Default Level
Level: 1.
Usage Guideline
Use this command to display DHCP snooping configuration settings.
Example
This example shows how to display DHCP snooping configuration settings.
Switch# show ip dhcp snooping
DHCP Snooping is enabled
DHCP Snooping is enabled on VLANs:
10, 15-18
Verification of MAC address is disabled
Information option of allowed on un-trusted interface is disabled
Interface Trusted Rate Limit
------------ ---------- ------------
eth3/0/1 no 10
eth3/0/8 no 50
eth3/0/9 yes no_limit
Switch#
17-15 show ip dhcp snooping binding
This command is used to display DHCP snooping binding entries.
show ip dhcp snooping binding [IP-ADDRESS] [MAC-ADDRESS] [vlan VLAN-ID] [interface
[INTERFACE-ID [, | -]]]
Parameters
IP-ADDRESS
(Optional) Specifies to display the binding entry based on the IP
address.
MAC-ADDRESS
(Optional) Specifies to display the binding entry based on the MAC
address.
vlan VLAN-ID
(Optional) Specifies to display the binding entry based on the VLAN.
interface INTERFACE-ID
(Optional) Specifies to display the binding entry based on the port ID.
,
(Optional) Specifies a series of interfaces, or separate a range of
interfaces from a previous range. No space is allowed before and after
the comma.
-
(Optional) Specifies a range of interfaces. No space is allowed before
and after the hyphen.
Default
None.
Command Mode