Owners manual

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
191
18. DHCPv6 Client Commands
18-1 clear ipv6 dhcp client
This command is used to restart the DHCPv6 client on an interface.
clear ipv6 dhcp client INTERFACE-ID
Parameters
INTERFACE-ID
Specifies the VLAN interface to restart the DHCPv6 client.
Default
None.
Command Mode
Privileged EXEC Mode.
Command Default Level
Level: 12.
Usage Guideline
Use this command to restart the IPv6 DHCP client on the specified interface.
Example
This example shows how to restart the DHCPv6 client for interface VLAN 1.
Switch# clear ipv6 dhcp client vlan1
Switch#
18-2 ipv6 dhcp client pd
This command is used to enable the Dynamic Host Configuration Protocol (DHCP) IPv6 client process to
request the prefix delegation through a specified interface. Use the no form of this command to disable
the request.
ipv6 dhcp client pd PREFIX-NAME [rapid-commit]
no ipv6 dhcp client pd
Parameters
PREFIX-NAME
Specifies the IPv6 general prefix name with a maximum of 32
characters.
rapid-commit
(Optional) Specifies to proceed with two-message exchange for prefix
delegation. The rapid-commit option will be filled in the Solicit message
to request two messages handshake.
Default
By default, this option is disabled.