Owners manual

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
204
21. Digital Diagnostics Monitoring (DDM)
Commands
21-1 show interfaces transceiver
This command is used to display the current SFP module operating parameters.
show interfaces [INTERFACE-ID [,|-] transceiver [detail]
Parameters
INTERFACE-ID [,|-]
(Optional) Specifies multiple interfaces for transceiver monitoring
status display. If no interface ID is specified, transceiver monitoring
statuses on all valid interfaces are displayed.
Default
None.
Command Mode
EXEC Mode or Any Configuration Mode.
Command Default Level
Level: 1.
Usage Guideline
Use this command to display the current SFP module operating transceiver monitoring parameters values
for specified ports.
Example
This example shows how to display current operating parameters for all ports valid for transceiver
monitoring.
Switch#show interfaces transceiver
++ : high alarm, + : high warning, - : low warning, -- : low alarm
mA: milliamperes, mW: milliwatts
Transceiver Monitoring traps: None
Port Temperature Voltage Bias Current TX Power RX Power
(Celsius) (V) (mA) (mW) (mW)
------- ------------ ------------ ------------ ------------ ------------
eth2/0/23 30.090 3.353 16.794(++) 0.258 0.000(--)
eth3/0/25 29.316 3.302 5.326 0.529 0.506
eth3/0/26 31.617 3.297 5.170 0.527 0.504
Total Entries: 3
Switch#