Owners manual

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
219
IPV6-ADDRESS
Specifies the IPv6 address of the equipment.
Default
None.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
The host name specified in this command needs to be qualified. To delete a static host entry, use the no
command.
Example
This example shows how to configure the mapping of the host name “www.abc.com” and the IP address
192.168.5.243.
Switch# configure terminal
Switch(config)# ip host www.abc.com 192.168.5.243
Switch(config)#
23-6 ip name-server
This command is used to configure the IP address of a domain name server. Use the no form of this
command to delete the configured domain name server.
ip name-server {IP-ADDRESS | IPV6-ADDRESS} [{IP-ADDRESS2 | IPV6-ADDRESS2}]
no ip name-server {IP-ADDRESS | IPV6-ADDRESS} [{IP-ADDRESS2 | IPV6-ADDRESS2}]
Parameters
IP-ADDRESS
Specifies the IPv4 address of the domain name server.
IPV6-ADDRESS
Specifies the IPv6 address of the domain name server.
IP-ADDRESS2…IP-
ADDRESS6
Specifies multiple IP addresses, separated by spaces. Up to four
servers can be specified.
Default
None.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
Use this command to configure a DNS server. When the system cannot obtain an answer from a DNS
server, it will attempt the subsequent server until it receives a response. If name servers are already