Owners manual

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
238
Switch# show ip arp inspection
Source MAC Validation : Disabled
Destination MAC Validation: Disabled
IP Address Validation : Disabled
VLAN State ACL Match Static ACL
----- ------------- ------------------------------- ----------
10 Enabled - -
VLAN ACL Logging DHCP Logging
----- ----------- ----------
10 Deny Deny
Switch#
Display Parameters
VLAN
The VLAN ID that enables ARP inspection.
Configuration
The configuration state of ARP inspection.
Enable: ARP inspection is enabled.
Disable: ARP inspection is enabled.
ACL Match
The name of ARP ACL that is specified.
Static ACL
The configuration of the static ACL.
Yes: Static ARP ACL is configured.
No: Static ARP ACL is not configured.
ACL logging
The state of logging for packets dropped or permitted based on ACL
matches.
None: ACL-matched packets are not logged.
Permit: Logging when packets are permitted by the configured ACL.
Deny: Logging when packets are dropped by the configured ACL.
All: ACL-matched packets are always logged.
DHCP Logging
The state of logging for packets dropped or permitted based on DHCP
bindings.
None: Prevent logging when packets are dropped or permitted by the
DHCP bindings.
Permit: Logging when packets are permitted by the DHCP bindings.
Deny: Logging when packets are dropped by the DHCP bindings.
All: Logging when packets are dropped or permitted by the DHCP
bindings.
Example
This example shows how to display the trust state of interface eth3/0/3.