Owners manual

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
239
Switch# show ip arp inspection interfaces eth3/0/3
Interface Trust State Rate(pps) Burst Interval
--------- ----------- --------- --------------
eth3/0/3 untrusted 30 5
Switch#
This example shows how to display the trust state of interfaces on the Switch.
Switch# show ip arp inspection interfaces
Interface Trust State Rate(pps) Burst Interval
--------- ----------- --------- -------------
eth3/0/1 untrusted 30 1
eth3/0/2 untrusted 30 1
eth3/0/3 untrusted 30 5
eth3/0/5 trusted None 1
eth3/0/6 untrusted 30 1
eth3/0/7 untrusted 30 1
eth3/0/8 untrusted 30 1
Total Entries: 7
Switch#
Display Parameters
Interface
The name of interface that enable ARP inspection.
Trust State
The state of the interface.
trusted: This interface is ARP inspection trusted port, all ARP packet
will be legal and not be authorized.
untrusted: This interface is ARP inspection untrusted port, all ARP
packet will be authorized.
Rate (pps)
The upper limit on the number of incoming packets processed per
second.
Burst Interval
The consecutive interval in seconds over which the interface is
monitored for the high rate of the ARP packets.
25-13 show ip arp inspection log
This command is used to display the ARP inspection log buffer.
show ip arp inspection log
Parameters
None.
Default