Owners manual

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
243
Switch# show errdisable recovery
ErrDisable Cause State Interval
----------------- ----------- -----------
psecure-violation enabled 200 seconds
storm-control disabled 300 seconds
arp-rate disabled 1000 seconds
dhcp-rate disabled 1000 seconds
loopback-detect disabled 1000 seconds
Interfaces that will be recovered at the next timeout:
Interface Errdisable Cause Time left(sec)
--------- ----------------- --------------
eth1/0/4 psecure-violation 179
Switch#
26-3 snmp-server enable traps errdisable
This command is used to enable sending SNMP notifications for error disabled state. Use the no form of
the command to disable sending SNMP notifications.
snmp-server enable traps errdisable [asserted] [cleared] [notification-rate TRAP-RATE]
no snmp-server enable traps errdisable [asserted] [cleared] [notification-rate]
Parameters
asserted
(Optional) Specifies to control the notifications when entering into the
error disabled state.
cleared
(Optional) Specifies to control the notifications when exiting from the
error disabled state.
notification-rate TRAP-RATE
(Optional) Specifies to configure the number of traps per minute. The
packets that exceed the rate will be dropped. The range is from 0 to
1000. The default value of 0 indicates that an SNMP trap will be
generated for every change of the error disabled state.
Default
By default, all notification types are disabled, and there is no limit for the notification rate.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
This command with the parameters asserted and cleared enables or disables the notifications for the
state change of the error disabled state. If you enter the command with one of the parameters, only the
specified notification type is enabled or disabled. The state or value of the other notification type will not
be affected.