Owners manual

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
256
multicast filtering-mode {forward-all | forward-unregistered | filter-unregistered}
no multicast filtering-mode
Parameters
forward-all
Specifies to flood all multicast packets based on the VLAN domain.
forward-unregistered
Specifies to forward registered multicast packets based on the
forwarding table and flood all unregistered multicast packets based on
the VLAN domain.
filter-unregistered
Specifies to forward registered packets based on the forwarding table
and filter all unregistered multicast packets.
Default
By default, the forward-unregistered option is enabled.
Command Mode
VLAN Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
This filtering mode is only applied to multicast packets that are destined for addresses other than those
reserved for multicast addresses.
Example
This example shows how to set the multicast filtering mode on VLAN 100 to filter unregistered.
Switch# configure terminal
Switch(config)# vlan 100
Switch(config-vlan)# multicast filtering-mode filter-unregistered
Switch(config-vlan)#
28-8 show mac-address-table
This command is used to display a specific MAC address entry or the MAC address entries for a specific
interface or VLAN.
show mac-address-table [dynamic | static] [address MAC-ADDR | interface [INTERFACE-ID |
vlan VLAN-ID]
Parameters
dynamic
(Optional) Specifies to display dynamic MAC address table entries
only.
static
(Optional) Specifies to display static MAC address table entries only.
address MAC-ADDR
(Optional) Specifies the 48-bit MAC address.
interface INTERFACE-ID
(Optional) Specifies to display information for a specific interface. Valid