Owners manual

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
269
Leave: 60.
Leave-all: 1000.
Command Mode
Interface Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
This command is used to configure the GVRP timer value on a port.
Example
This example shows how to configure the leave-all timer to 500 hundredths of a second on interface
eth1/0/1.
Switch# configure terminal
Switch(config)# interface eth1/0/1
Switch(config-if)# gvrp timer leave-all 500
Switch(config-if)#
29-8 show gvrp configuration
This command is used to display the GVRP settings.
show gvrp configuration [interface [INTERFACE-ID [,|-]]]
Parameters
configuration
Specifies to display the GVRP configuration. If the interface is not
specified, the GVRP global configuration is displayed.
interface
Specifies to display the GVRP interface configuration. If the interface
ID is not specified, all interfaces are displayed.
INTERFACE-ID [,|-]
(Optional) Specifies the interfaces used to display the configuration.
Specify a single interface or a range of interfaces, separated by a
hyphen, or a series of interfaces separated by comma.
Default
None.
Command Mode
EXEC Mode or Any Configuration Mode.
Command Default Level
Level: 1.
Usage Guideline
This command only displays GVRP related configurations.
Example
This example shows how to display the GVRP configuration for the global configuration.