Owners manual

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
301
32-8 show interfaces status
This command is used to display the Switch’s port connection status.
show interfaces [INTERFACE-ID [,|-]] status
Parameters
INTERFACE-ID
(Optional) Specifies the interface ID. If no interface is specified, the
connection status of all switch ports will be displayed.
Default
None.
Command Mode
EXEC Mode or Any Configuration Mode.
Command Default Level
Level: 1.
Usage Guideline
This command displays the Switch’s port connection status.
Example
This example shows how to display the Switch’s port connection status.
Switch# show interfaces eth1/0/1-8,3/0/1-2 status
Port Status VLAN Duplex Speed Type
------------- ------------- ------------ ------- -------------- -------------
eth1/0/1 not-connected 1 auto auto 1000BASE-T
eth1/0/2 not-connected 1 auto auto 1000BASE-T
eth1/0/3 not-connected 1 auto auto 1000BASE-T
eth1/0/4 not-connected 1 auto auto 1000BASE-T
eth1/0/5 not-connected 1 auto auto 1000BASE-T
eth1/0/6 not-connected 1 auto auto 1000BASE-T
eth1/0/7 not-connected 1 auto auto 1000BASE-T
eth1/0/8 connected trunk a-full a-1000 1000BASE-T
eth3/0/1 connected 2 a-full a-1000 1000BASE-T
eth3/0/2 not-connected 1 auto auto 1000BASE-T
Total Entries: 10
Switch#
32-9 show interfaces utilization
This command is used to display the Switch’s port utilization.
show interfaces [INTERFACE-ID [,|-]] utilization