Owners manual

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
302
Parameters
utilization
(Optional) Specifies to display the utilization information.
INTERFACE-ID
(Optional) Specifies the interface ID. If no interface is specified, the
utilization of all physical port interfaces will be displayed.
Default
None.
Command Mode
EXEC Mode or Any Configuration Mode.
Command Default Level
Level: 1.
Usage Guideline
This command displays the Switch’s physical port utilization.
Example
This example shows how to display the Switch’s port utilization.
Switch# show interfaces utilization
Port TX packets/sec RX packets/sec Utilization
----------- ------------- -------------- -----------
eth1/0/1 0 0 0
eth1/0/2 1488109 0 50
eth1/0/3 0 0 0
eth1/0/4 0 1488109 50
eth1/0/5 0 0 0
eth1/0/6 0 0 0
eth1/0/7 0 0 0
eth1/0/8 0 0 0
Total Entries: 8
Switch#
32-10 show interfaces auto-negotiation
This command is used to display detailed auto-negotiation information of physical port interfaces.
show interfaces [INTERFACE-ID [,|-]] auto-negotiation
Parameters
auto-negotiation
Specifies to display detailed auto-negotiation information.
INTERFACE-ID
(Optional) Specifies the interface ID. If no interface is specified, the
auto-negotiation information on all physical port interfaces will be
displayed.