Owners manual

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
303
Default
None.
Command Mode
EXEC Mode or Any Configuration Mode.
Command Default Level
Level: 1.
Usage Guideline
This command displays the auto-negotiation information.
Example
This example shows how to display auto-negotiation information.
Switch# show interfaces eth1/0/1-2 auto-negotiation
eth1/0/1
Auto Negotiation: Disabled
eth1/0/2
Auto Negotiation: Enabled
Speed auto downgrade: Disabled
Remote Signaling: Detected
Configure Status: Configuring
Capability Bits: 10M_Half, 10M_Full, 100M_Half, 100M_Full, 1000M_Full
Capability Advertised Bits: 10M_Half, 10M_Full, 100M_Half, 100M_Full, 1000M_Full
Capability Received Bits: -
RemoteFaultAdvertised: Disabled
RemoteFaultReceived: NoError
Switch#
32-11 shutdown
This command is used to disable an interface. Use the no form of the command to enable an interface.
shutdown
no shutdown
Parameters
None.
Default
By default, this option is no shutdown.
Command Mode
Interface Configuration Mode.
Command Default Level