Owners manual

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
304
Level: 12.
Usage Guideline
The physical port is valid for this configuration. This command is also configurable for port channel
member ports.
The command will cause the port to enter the disabled state. Under the disabled state, the port will not be
able to receive or transmit any packets. Using the no shutdown command will put the port back into the
enabled state. When a port is shut down, the link status will also be turned off.
Example
This example shows how to enter the shutdown command to disable the port state of interface port 1/0/1.
Switch# configure terminal
Switch(config)# interface eth1/0/1
Switch(config-if)# shutdown