Owners manual

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
28
,
(Optional) Specifies a series of interfaces, or separate a range of
interfaces from a previous range. No space is allowed before and after
the comma.
-
(Optional) Specifies a range of interfaces. No space is allowed before
and after the hyphen.
mac-address MAC-ADDRESS
Specifies the MAC address to be initialized.
Default
None.
Command Mode
Privileged EXEC Mode.
Command Default Level
Level: 12.
Usage Guideline
Under the multi-host mode, specify an interface ID to initialize a specific port.
Under the multi-auth mode, specify a MAC address to initialize a specific MAC address.
Example
This example shows how to initialize the authenticator state machine on Ethernet port 1/0/1.
Switch# dot1x initialize interface eth1/0/1
Switch#
3-7 dot1x max-req
This command is used to configure the maximum number of times that the backend authentication state
machine will retransmit an Extensible Authentication Protocol (EAP) request frame to the supplicant
before restarting the authentication process. Use the no form of the command to reset to the default
setting.
dot1x max-req TIMES
no dot1x max-req
Parameters
TIMES
Specifies the number of times that the Switch retransmits an EAP
frame to the supplicant before restarting the authentication process.
The range is 1 to 10.
Default
By default, this value is 2.
Command Mode
Interface Configuration Mode.
Command Default Level
Level: 12.