Owners manual

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
315
Command Default Level
Level: 1.
Usage Guideline
Use this command to display the IMPB configuration or use the show ip ip-mac-port-binding violation
command to display the entries blocked because of the IMPB check violation.
Example
This example shows how to display all of the entries blocked by the IMPB access control.
Switch# show ip ip-mac-port-binding violation
Port VLAN MAC Address
------- --------- -------------------
eth3/0/3 1 01-00-0c-cc-cc-cc
eth3/0/3 1 01-80-c2-00-00-00
eth3/0/4 1 01-00-0c-cc-cc-cd
eth3/0/4 1 01-80-c2-00-00-01
Total Entries: 4
Switch#
This example shows how to display the IMPB configuration for all ports.
Switch# show ip ip-mac-port-binding
Port Mode
---------- ------------
eth3/0/1 Strict
eth3/0/2 Strict
eth3/0/3 Loose
eth3/0/4 Loose
Total Entries: 4
Switch#
35-4 snmp-server enable traps ip-mac-port-binding
This command is used to enable the sending of the SNMP notifications for IP-MAC-Port Binding. Use the
no form of the command to disable sending SNMP notifications.
snmp-server enable traps ip-mac-port-binding
no snmp-server enable traps ip-mac-port-binding
Parameters
None.
Default
By default, this option is disabled.