Owners manual

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
330
Usage Guideline
When the forcible logout feature is enabled, a ping packet from an authenticated host to the JWAC switch
with a TTL of 1 will be regarded as a logout request and the host will be moved back to unauthenticated
state.
Example
This example shows how to enable the JWAC forcible logout function.
Switch# configure terminal
Switch(config)# jwac forcible-logout
Switch(config)#
38-4 jwac max-authenticating-user
This command is used to configure the maximum authenticating user number on the specified interface.
Use the no form of this command to return to the default setting.
jwac max-authenticating-user NUMBER
no jwac max-authenticating-user
Parameters
NUMBER
Specifies to set the maximum number of users being authenticated.
The range is from 1 to 100.
Default
By default, this value is 100.
Command Mode
Interface Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
This command is used to configure the maximum authenticating user number for JWAC on the specified
interface.
Example
This example shows how to configure the maximum authenticating user number for JWAC to 10 on
interface eth1/0/1.
Switch# configure terminal
Switch(config)# interface eth1/0/1
Switch(config-if)# jwac max-authenticating-user 10
Switch(config-if)#
38-5 jwac authenticate-page language
This command is used to choose the authenticate page language. Use the no form of this command to
return to the default setting.