Owners manual

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
33
Switch# show dot1x
802.1X : Enabled
Trap State : Enabled
Switch#
This example shows how to display the dot1X configuration on Ethernet port 1/0/1.
Switch# show dot1x interface eth1/0/1
Interface : eth1/0/1
PAE : Authenticator
Control Direction : Both
Port Control : Auto
Tx Period : 30 sec
Supp Timeout : 30 sec
Server Timeout : 30 sec
Max-req : 2 times
Forward PDU : Disabled
Switch#
3-13 show dot1x diagnostics
This command is used to display IEEE 802.1X diagnostics. If no interface is specified, information about
all interfaces will be displayed.
show dot1x diagnostics [interface INTERFACE-ID [, | -]]
Parameters
interface INTERFACE-ID
(Optional) Specifies to display the dot1x diagnostics on the specified
interface or range of interfaces. If not specified, information about all
interfaces will be displayed.
,
(Optional) Specifies a series of interfaces, or separate a range of
interfaces from a previous range. No space is allowed before and after
the comma.
-
(Optional) Specifies a range of interfaces. No space is allowed before
and after the hyphen.
Default
None.
Command Mode
EXEC Mode or Any Configuration Mode.
Command Default Level
Level: 1.
Usage Guideline