Owners manual

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
361
The LLDP transmission interval must be greater than or equal to four times of the transmission delay
timer.
Example
This example shows how to configure the transmission delay timer to 8 seconds.
Switch# configure terminal
Switch(config)# lldp tx-delay 8
Switch(config)#
41-16 lldp tx-interval
This command is used to configure the LLDPDUs transmission interval on the Switch. Use the no form of
this command to return to the default settings.
lldp tx-interval SECONDS
no lldp tx-interval
Parameters
SECONDS
Specifies the interval between consecutive transmissions of LLDP
advertisements on each physical interface. The range is from 5 to
32768 seconds.
Default
By default, this value is 30 seconds.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
This interval controls the rate at which LLDP packets are sent.
Example
This example shows how to configure that LLDP updates are sent every 50 seconds.
Switch# configure terminal
Switch(config)# lldp tx-interval 50
Switch(config)#
41-17 snmp-server enable traps lldp
This command is used to enable the LLDP and LLDP-MED trap state.
snmp-server enable traps lldp [med]
no snmp-server enable traps lldp [med]