Owners manual

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
364
Default
None.
Command Mode
EXEC Mode or Any Configuration Mode.
Command Default Level
Level: 1.
Usage Guideline
This command is used to display the LLDP system’s global configurations.
Example
This example shows how to display the LLDP system’s global configuration status.
Switch#show lldp
LLDP System Information
Chassis ID Subtype : MAC Address
Chassis ID : 00-01-02-03-04-00
System Name : Switch
System Description : Gigabit Ethernet SmartPro Switch
System Capabilities Supported: Repeater, Bridge
System Capabilities Enabled : Repeater, Bridge
LLDP-MED System Information:
Device Class : Network Connectivity Device
Hardware Revision : A1
Firmware Revision : 1.00.006
Software Revision : 1.00.016
Serial Number :
Manufacturer Name : D-Link
Model Name : DGS-1510-28P Gigabit Ethernet SmartPro Switch
Asset ID :
PoE Device Type : PSE Device
PoE PSE Power Source : Primary
LLDP Configurations
LLDP State : Disabled
LLDP Forward State : Disabled
Message TX Interval : 30
Message TX Hold Multiplier: 4
ReInit Delay : 2
TX Delay : 2
LLDP-MED Configuration:
Fast Start Repeat Count : 4
Switch#
41-21 show lldp interface
This command is used to display the LLDP configuration at the physical interface.