Owners manual

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
366
Switch#show lldp interface ethernet 1/0/1
Port ID: eth1/0/1
------------------------------------------------------------------------------
Port ID :eth1/0/1
Admin Status :TX and RX
Notification :Disabled
Basic Management TLVs:
Port Description :Enabled
System Name :Enabled
System Description :Enabled
System Capabilities :Enabled
Enabled Management Address:
(None)
IEEE 802.1 Organizationally Specific TLVs:
Port VLAN ID :Enabled
Enabled Port_and_Protocol_VLAN_ID
1, 2, 3
Enabled VLAN Name
1-3
Enabled Protocol_Identity
EAPOL, LACP, GVRP, STP
IEEE 802.3 Organizationally Specific TLVs:
MAC/PHY Configuration/Status :Enabled
Link Aggregation :Disabled
Maximum Frame Size :Disabled
LLDP-MED Organizationally Specific TLVs:
LLDP-MED Capabilities TLV :Enabled
LLDP-MED Network Policy TLV :Disabled
LLDP-MED Extended Power Via MDI PSE TLV :Disabled
LLDP-MED Inventory TLV :Disabled
Switch#
Display Parameters
Enabled Management
Address
Displays the enabled IPv4/IPv6 addresses. The indicated string
“(None)” means that the user did not configure the management
address with the lldp management-address command or the enabled
default IPv4 and IPv6 addresses are not applicable.
Enabled Port and Protocol
VLAN ID
This indicating string is shown when there are enabled port and
protocol VLANs. The VLAN list is the configured enabled VLANs. If
there is no configured PPVID VLAN, the string is “(None)”.
Enabled VLAN Name
This indicating string is shown when there are enabled VLANs for
sending VLAN Name TLVs. The VLAN list includes the configured
enabled VLANs. If there is no configured VLAN for the VLAN Name
TLV, the string is “(None)”.