Owners manual

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
396
Switch# configure terminal
Switch(config)# vlan 4
Switch(config-vlan)# no ipv6 mld snooping mrouter learn pimv6
Switch(config-vlan)#
45-6 ipv6 mld snooping proxy-reporting
This command is used to enable the proxy-reporting function. Use the no form of this command to disable
the proxy-reporting function.
ipv6 mld snooping proxy-reporting [source IPV6-ADDRESS]
no ipv6 mld snooping proxy-reporting
Parameters
source IPV6-ADDRESS
(Optional) Specifies the source IP address of proxy reporting.
Default
By default, this option is disabled.
Command Mode
Interface Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
The command is only available for VLAN interface configuration.
When the function proxy reporting is enabled, the received multiple MLD report or leave packets will be
integrated into one report before being sent to the router port. Proxy reporting source IP will be used as
source IP of the report, Zero IP address will be used when the proxy reporting source IP is not set.
Example
This example shows how to enable MLD snooping proxy-reporting on VLAN 1.
Switch# configure terminal
Switch(config)# vlan 1
Switch(config-vlan)# ipv6 mld snooping proxy-reporting
Switch(config-vlan)#
45-7 ipv6 mld snooping querier
This command is used to enable the MLD snooping querier on the Switch. Use the no form of this
command to disable the MLD snooping querier function.
ipv6 mld snooping querier
no ipv6 mld snooping querier