Owners manual

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
415
Interface Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
When entering the cost value, do not include a comma in the entry. For example, enter 1000, not 1,000.
Example
This example shows how to configure the interface’s path cost.
Switch# configure terminal
Switch(config)# interface eth3/0/1
Switch(config-if)# spanning-tree mst 0 cost 17031970
Switch(config-if)#
46-6 spanning-tree mst configuration
This command is used to enter the MST Configuration Mode. To return to the default settings, use the no
form of this command.
spanning-tree mst configuration
no spanning-tree mst configuration
Parameters
None.
Default
None.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
This command is used to enter the MST Configuration Mode.
Example
This example shows how to enter the MST Configuration Mode.
Switch# configure terminal
Switch(config)# spanning-tree mst configuration
Switch(config-mst)#
46-7 spanning-tree mst max-hops
This command is used to configure the MSTP maximum hop count value. Use the no form of the
command to reset to the default setting.