Owners manual

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
443
50. Power over Ethernet (PoE) Commands
50-1 poe pd description
This command is used to configure the description for the PD connected to the PoE port. Use the no form
of this command to clear the description.
poe pd description TEXT
no poe pd description
Parameters
TEXT
Specifies the string that describes the PD connected to a PoE
interface. The maximum length is 32 characters.
Default
None.
Command Mode
Interface Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
This command is used to configure a description for the PD connected to the port.
Example
This example shows how to configure the PoE PD description on interface eth3/0/1.
Switch# configure terminal
Switch(config)# interface eth3/0/1
Switch(config-if)# poe pd description For VOIP usage
Switch(config-if)#
50-2 poe pd legacy-support
This command is used to enable the support of legacy PD. Use the no form of this command to disable it.
poe pd legacy-support
no poe pd legacy-support
Parameters
None.
Default
By default, this option is disabled.
Command Mode