Owners manual

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
448
Switch# configure terminal
Switch(config)# poe unit 1 usage-threshold 50
Switch(config)#
50-7 snmp-server enable traps poe
This command is used to enable the sending of power over ethernet notifications. Use the no form of the
command to disable sending power over Ethernet notifications.
snmp-server enable traps poe [unit UNIT-ID]
no snmp-server enable traps poe [unit UNIT-ID]
Parameters
UNIT-ID
Specifies the stacking unit’s ID to be configured. This parameter is only
available, if stacking is enabled.
Default
By default, this option is disabled.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
Use this command to enable sending power over ethernet usage threshold exceeding traps.
Example
This example shows how to enable trap for power over ethernet event.
Switch#configure terminal
Switch(config)#snmp-server enable traps poe
Switch(config)#
50-8 clear poe statistic
This command is used to clear the statistic counters on the port.
clear poe statistic {all | interface INTERFACE-ID [,|-]}
Parameters
all
Specifies to clear PoE statistics for all interfaces.
interface INTERFACE-ID
Specifies the interface ID of an interface.
,
(Optional) Specifies a series of interfaces, or separate a range of
interfaces from a previous range. No spaces before and after the