Owners manual

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
449
comma.
-
(Optional) Specifies a range of interfaces. No spaces before and after
the hyphen.
Default
None.
Command Mode
Privilege EXEC Mode.
Command Default Level
Level: 12.
Usage Guideline
There are counters on ports to record the statistic and they can be shown by show poe power-inline
statistics command. Use this command to clear all the counter values on the port.
Example
This example shows how to clear statistics on interface eth3/0/1.
Switch# clear poe statistic interface eth3/0/1
Switch#
50-9 show poe power-inline
This command is used to display the Power over Ethernet (PoE) status for the specified PoE port, or for
all PoE ports in the switch system.
show poe power-inline [INTERFACE-ID [, | -]] {status | configuration | statistics | measurement |
lldp-classification}
Parameters
INTERFACE-ID
(Optional) Specifies the interface to be displayed.
,
(Optional) Specifies a series of interfaces, or separate a range of
interfaces from a previous range. No spaces before and after the
comma.
-
(Optional) Specifies a range of interfaces. No spaces before and after
the hyphen.
status
Specifies to display the port PoE status.
configuration
Specifies to display the port configuration information.
statistics
Specifies to display the port error counters.
measurement
Specifies to display the port voltage, current, consumed power, and
temperature.
lldp-classification
Specifies to display the data link layer classification using information
of power via MDI TLV.
Default
None