Owners manual

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
452
Switch# show poe power-inline statistics
Interface MPS Absent Overload Short Power Denied Invalid Signature
--------- ---------- -------- ----- ------------ -----------------
eth3/0/1 2 5 0 10 7
eth3/0/2 2 1 0 3 9
!--- Output suppressed.
eth4/0/1 2 0 0 2 3
eth4/0/2 2 0 0 1 0
eth4/0/3 2 0 0 5 1
eth4/0/4 2 0 0 0 0
!--- Output suppressed.
eth5/0/24 2 2 0 0 0
eth5/0/25 2 1 1 0 0
Switch#
Display Parameters
MPS Absent
Increased if the PSE stops to provide power to the PI due to the PSE
cannot monitor the valid MPS of PD on the PI.
Overload
If the PD is drawing too much power to exceed the maximum output
power that the port can supply, then the overload counter is increased.
Short
If the PD’s internal circuit is shorted for some reason, then this counter
is increased.
Power Denied
If the PoE software system decides to disallow providing power to the
attached PD, then this counter is increased.
Invalid Signature
Increased if the PSE detects a PD who has an invalid PD signature.
Example
This example shows how to display the PoE power inline measurement.
Switch# show poe power-inline measurement
Interface Voltage(V) Current(mA) Temperature(C) Power(W)
--------- ---------- ----------- -------------- --------
eth3/0/1 54.2 109 35 5.9
eth3/0/2 55 196 38 10.8
!--- Output suppressed.
eth4/0/1 54.6 197 32 10.7
eth4/0/2 54.8 286 36 15.7
eth4/0/3 n/a n/a n/a n/a
eth4/0/4 n/a n/a n/a n/a
!--- Output suppressed.
eth5/0/24 n/a n/a n/a n/a
eth5/0/25 n/a n/a n/a n/a
Switch#
This example shows how to display the PoE power inline LLDP classification.