Owners manual

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
460
Command Mode
Interface Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
Use this command to add or delete a time range profile for the port shutdown schedule. When the
schedule is up, the specific port will be disabled.
Example
This example shows how to add a time range profile for the port shutdown schedule.
Switch# configure terminal
Switch(config)# interface eth1/0/1
Switch(config-if)# power-saving shutdown time-range off-duty
Switch(config-if)#
51-7 show power-saving
This command is used to display the power saving configuration information.
show power-saving [link-detection] [dim-led] [port-shutdown] [hibernation] [eee]
Parameters
link-detection
(Optional) Specifies to display the link detection state.
dim-led
(Optional) Specifies to display the dim LED state.
port-shutdown
(Optional) Specifies to display the port shutdown state.
hibernation
(Optional) Specifies to display the hibernation state.
eee
(Optional) Specifies to display the EEE state.
Default
None.
Command Mode
EXEC Mode or Any Configuration Mode.
Command Default Level
Level: 1.
Usage Guideline
If no optional keywords were specified, all power saving configuration information will be displayed.
Example
This example shows how to display all power saving configuration information.