Owners manual

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
518
Command Mode
EXEC Mode or Any Configuration Mode.
Command Default Level
Level: 1.
Usage Guideline
This command is used to display the settings and status of the Safeguard Engine.
Example
This example shows how to display the settings and current status of the Safeguard Engine.
Switch#show cpu-protect safeguard
Safeguard Engine State: Disabled
Safeguard Engine Status: Normal
Utilization Thresholds:
Rising :30%
Falling :20%
Switch#
Display Parameters
Safeguard Engine Status
Displays the current mode that CPU utilization stays. The possible
displayed strings are:
Exhausted: If the CPU utilization is higher than the configured rising
threshold, it will enter Exhausted Mode and Safeguard Engine will take
actions. The Safeguard Engine mechanism ceases till the utilization is
lower than the falling threshold.
Normal: The Safeguard Engine is not triggered to take actions.
56-6 show cpu-protect sub-interface
This command is used to display the rate limit and statistics by sub-interface.
show cpu-protect sub-interface {manage | protocol | route} [UNIT-ID]
Parameters
UNIT-ID
(Optional) Specifies the unit ID to display the rate limit configuration
and statistics by sub-interface.
Default
None.
Command Mode
EXEC Mode or Any Configuration Mode.
Command Default Level
Level: 1.