Owners manual

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
532
Switch# configure terminal
Switch(config)# crypto pki trustpimport TP1
Switch(ca-trustpoint)# primary
Switch(ca-trustpoint)#
58-4 crypto pki certificate chain
This command is used to enter into the certificate chain configuration mode.
crypto pki certificate chain NAME
Parameters
NAME
Specifies the name for the trust-point.
Default
None.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 15.
Usage Guideline
Use this command to enter into certificate chain configuration mode. If the specified trust-point name
doesn’t exist, an error message will be displayed.
Example
This example shows how to enter into certificate chain configuration mode.
Switch# configure terminal
Switch(config)# crypto pki certificate chain TP1
Switch(trustpoint)#
58-5 primary
This command is used to assign a specified trust-point as the primary trust-point of the Switch.
primary
no primary
Parameters
None.
Default
By default, this option is disabled.
Command Mode