Owners manual

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
544
Switch#configure terminal
Switch(config)#snmp-server name SiteA-switch
SiteA-switch(config)#
59-10 snmp-server trap-sending disable
This command is used to disable the port’s trap sending state. Use the no command to disable the port’s
trap sending state.
snmp-server trap-sending disable
no snmp-server trap-sending disable
Parameters
None.
Default
By default, this option is enabled.
Command Mode
Interface Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
Use this command to disable the port to send SNMP notification traps out of the configured port. If the
sending is disabled, then SNMP notification traps generated by the system are not allowed to transmit out
of the port. The SNMP traps generated by other system and forwarded to the port is not subject to this
restriction.
Example
This example shows how to disable the sending of the notification traps out of Ethernet interface eth3/0/8.
Switch# configure terminal
Switch(config)# interface eth3/0/8
Switch(config-if)# snmp-server trap-sending disable
Switch(config-if)#
59-11 snmp-server service-port
This command is used to configure the SNMP UDP port number. Use the no form of this command to
reset the UDP port number to default value.
snmp-server service-port PORT-NUMBER
no snmp-server service-port
Parameters