Owners manual

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
546
Switch# configure terminal
Switch(config)# snmp-server response broadcast-request
Switch(config)#
59-13 snmp trap link-status
This command is used to enable the notification of link-up and link-down events that occurred on the
interface. Use the no form of this command to disable the notification.
snmp trap link-status
no snmp trap link-status
Parameters
None.
Default
By default, this option is enabled.
Command Mode
Interface Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
This command is used to enable or disable the sending of link-up and link-down traps on an interface.
Example
This example shows how to disable the generation of link-up and link-down traps on eth1/0/1.
Switch# configure terminal
Switch(config)# interface eth1/0/1
Switch(config-if)# no snmp trap link-status
Switch(config-if)#
59-14 show snmp
This command is used to display the SNMP settings.
show snmp {community | host | view | group | engineID}
Parameters
community
Specifies to display SNMP community information.
host
Specifies to display SNMP trap recipient information.
view
Specifies to display SNMP view information.
group
Specifies to display SNMP group information.