Owners manual

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
572
,
(Optional) Specifies a series of interfaces, or separate a range of
interfaces from a previous range. No space before and after the
comma.
-
(Optional) Specifies a range of interfaces. No space before and after
the hyphen.
Default
None.
Command Mode
EXEC Mode or Any Configuration Mode.
Command Default Level
Level: 1.
Usage Guideline
Use this command to display Spanning Tree interface level configuration. The command can be used for
all STP versions.
Example
This example shows how to display spanning tree configuration information for interface eth3/0/1.
Switch# show spanning-tree configuration eth3/0/1
eth3/0/1
Spanning tree state: enabled
Port path cost: 4,
Port priority: 128,
Link type: auto
Port fast: edge
Hello time: 2 seconds
Guard root: disabled
TCN filter: enabled
Bpdu forward: enabled
Switch#
61-4 snmp-server enable traps stp
This command is used to enable the spanning tree to send SNMP notifications for STP. Use the no form
of the command to disable the sending of notifications for STP.
snmp-server enable traps stp [new-root] [topology-chg]
no snmp-server enable traps stp [new-root] [topology-chg]
Parameters
new-root
(Optional) Specifies the sending of STP new root notification.
topology-chg
(Optional) Specifies the sending of STP topology change notification.
Default