Owners manual

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
588
63. Storm Control Commands
63-1 snmp-server enable traps storm-control
This command is used enable or control the command to enable sending SNMP notifications for storm
control. Use the no form of the command to disable sending SNMP notifications.
snmp-server enable traps storm-control [storm-occur] [ storm-clear]
no snmp-server enable traps storm-control [storm-occur] [ storm-clear]
Parameters
storm-occur
(Optional) Specifies to send a notification when a storm event is
detected.
storm-clear
(Optional) Specifies to send a notification when a storm event is
cleared.
Default
By default, this option is disabled.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
This command with keyword storm-occur and storm-clear enables or disables the notifications for storm
control module. If no optional keywords is specified, both storm-occur and storm-clear notifications are
enabled or disabled. If you enter the command with a keyword, only the specified notification type is
enabled or disabled.
Example
This example shows how to enable sending trap for storm control for both storm occurred and cleared.
Switch#configure terminal
Switch(config)#snmp-server enable traps storm-control
Switch(config)#
63-2 storm-control
This command is used to configure the device to protect the device from broadcast, multicast, and DA
unknown packet storm attacks. Use the no form of this command to restore the function to its default
settings.
storm-control {{broadcast | multicast | unicast} level {pps PPS-RISE [PPS-LOW] | kbps KBPS-
RISE [KBPS-LOW] | LEVEL-RISE [LEVEL-LOW]} | action {shutdown | drop | none}}
no storm-control {broadcast | multicast | unicast | action}