Owners manual

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
591
Switch# configure terminal
Switch(config)# storm-control polling interval 15
Switch(config)#
63-4 show storm-control
This command is used to display the current storm control settings.
show storm-control interface INTERFACE-ID [, | -] [broadcast | multicast | unicast]
Parameters
INTERFACE-ID
Specifies the port’s interface ID.
,
(Optional) Specifies a series of interfaces, or separate a range of
interfaces from a previous range. No space is allowed before and after
the comma.
-
(Optional) Specifies a range of interfaces. No space is allowed before
and after the hyphen.
broadcast
Specifies to display the current broadcast storm setting.
multicast
Specifies to display the current multicast storm setting.
unicast
Specifies to display the current unicast (DLF) storm setting.
Default
None.
Command Mode
EXEC Mode or Any Configuration Mode.
Command Default Level
Level: 1.
Usage Guideline
If the interface ID is not specified, all interfaces configurations will be displayed.
If the packet type is not specified, all types of storm control settings will be displayed.
Example
This example shows how to display the current broadcast storm control settings.