Owners manual

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
595
surveillance vlan aging MINUTES
no surveillance vlan aging
Parameters
MINUTES
Specifies the aging time of surveillance VLAN. The range is from 1 to
65535 minutes.
Default
By default, this aging time is 720 minutes.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
Use this command to configure the aging time for aging out the surveillance device and the surveillance
VLAN automatically learned member ports.
When the last surveillance device connected to the port stops sending traffic, and the MAC address of
this surveillance device is aged out, the surveillance VLAN aging timer will be started. The port will be
removed from the surveillance VLAN after expiration of surveillance VLAN aging timer.
If the surveillance traffic resumes during the aging time, the aging timer will be cancelled.
Example
This example shows how to configure the aging time of surveillance VLAN to 30 minutes.
Switch# configure terminal
Switch(config)#surveillance vlan aging 30
Switch(config)#
64-3 surveillance vlan enable
This command is used to enable the surveillance VLAN state of ports. Use the no form of the command
to disable the surveillance vlan state of ports.
surveillance vlan enable
no surveillance vlan enable
Parameters
None.
Default
By default, this option is disabled.
Command Mode
Interface Configuration Mode.
Command Default Level