Owners manual

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
597
maximum of 32 characters.
Default
OUI Vendor Mnemonic Name
F0:7D:68:0x:xx:xx D-Link D-Link IP camera
28:10:7B:00:00:00 ~ 28:10:7B:2F:FF:FF D-Link Network camera, Video server, NVR
Command Mode
Global Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
Use this command to add user-defined OUI(s) for the surveillance VLAN. The OUI for surveillance VLAN
are used to identify the surveillance traffic by the surveillance VLAN function.
If the source MAC addresses of the received packet matches any of the OUI pattern, the received packet
is determined as a surveillance packet.
The user-defined OUI cannot be the same as the default OUI.
The default OUI cannot be deleted.
Example
This example shows how to add a user-defined OUI for surveillance devices.
Switch# configure terminal
Switch(config)# surveillance vlan mac-address 00-01-02-03-00-00 FF-FF-FF-FF-00-00
component-type vms description user1
Switch(config)#
64-5 surveillance vlan qos
This command is used to configure the CoS priority for the incoming surveillance VLAN traffic. Use the no
form of the command to reset to default setting.
surveillance vlan qos COS-VALUE
no surveillance vlan qos
Parameters
COS-VALUE
Specifies the priority of surveillance VLAN. The available value is from
0 to 7.
Default
The default value 5.
Command Mode
Global Configuration Mode.