Owners manual

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
598
Command Default Level
Level: 12.
Usage Guideline
The surveillance packets arriving at the surveillance VLAN enabled port are marked to the COS specified
by the command.
The remarking of COS allows the surveillance VLAN traffic to be distinguished from data traffic in quality
of service.
Example
This example shows how to configure the priority of the surveillance VLAN to be 7.
Switch# configure terminal
Switch(config)# surveillance vlan qos 7
Switch(config)#
64-6 show surveillance vlan
This command is used to display the surveillance VLAN configurations.
show surveillance vlan [ interface [ INTERFACE-ID [, | -] ] ]
show surveillance vlan device [ interface [ INTERFACE-ID [, | -] ] ]
Parameters
device
Specifies to display the learned surveillance devices information
interface
(Optional) Specifies to display surveillance VLAN information of ports.
INTERFACE-ID
(Optional) Specifies the port to be displayed.
,
(Optional) Specifies a series of interfaces, or separate a range of
interfaces from a previous range. No space is allowed before and after
the comma.
-
(Optional) Specifies a range of interfaces. No space is allowed before
and after the hyphen.
Default
None.
Command Mode
EXEC Mode or Any Configuration Mode.
Command Default Level
Level: 1.
Usage Guideline
Use this command to display the surveillance VLAN configurations.
The show surveillance vlan command is used to display the surveillance VLAN global configurations.
The show surveillance vlan interface command is used to display the surveillance vlan configurations
on the interfaces.