Owners manual

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
630
Use the no command to delete the SNTP server entry. To delete an entry, specify the information exactly
the same as the originally configured setting. The time obtained from the SNTP server refers to the UTC
time.
Example
This example shows how to configure a switch to allow its software clock to be synchronized with the
clock by the SNTP server at IP address 192.168.22.44.
Switch# configure terminal
Switch(config)# sntp server 192.168.22.44
Switch(config)#
68-7 sntp enable
This command is used to enable the SNTP function. Use the no form of this command to disable the
SNTP function.
sntp enable
no sntp enable
Parameters
None.
Default
By default, this option is disabled.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
This command is used to enable or disable the SNTP function.
Example
This example shows how to enable the SNTP function.
Switch# configure terminal
Switch(config)# sntp enable
Switch(config)#
68-8 sntp interval
This command is used to set the interval for the SNTP client to synchronize its clock with the server.
sntp interval SECONDS
no sntp interval