Owners manual

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
650
the voice vlan enable command in the interface configuration mode need to be enabled for a port to start
the voice VLAN function.
Example
This example shows how to enable the voice VLAN function on the physical port eth1/0/1.
Switch# configure terminal
Switch(config)# interface eth1/0/1
Switch(config-if)# voice vlan enable
Switch(config-if)#
72-4 voice vlan mac-address
This command is used to add the user-defined voice device OUI. Use the no form of this command to
delete the user-defined voice device OUI.
voice vlan mac-address MAC-ADDRESS MASK [description TEXT]
no voice vlan mac-address MAC-ADDRESS MASK
Parameters
MAC-ADDRES
Specifies the OUI MAC address.
MASK
Specifies the OUI MAC address matching bitmask.
description TEXT
(Optional) Specifies the description for the user defined OUI with a
maximum of 32 characters.
Default
The default OUI is listed in the following table:
OUI Vendor
00:E0:BB 3COM
00:03:6B Cisco
00:E0:75 Veritel
00:D0:1E Pingtel
00:01:E3 Siemens
00:60:B9 NEC/Philips
00:0F:E2 Huawei-3COM
00:09:6E Avaya
Command Mode
Global Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline