Owners manual

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
696
not configure the bandwidth attribute and authenticates successfully, the device will not assign any
bandwidth to the port. If the bandwidth attribute is configured on the RADIUS server with a value of “0”,
the effective bandwidth will be set “no_limited”, and if the bandwidth is configured less than “0” or greater
than maximum supported value, the bandwidth will be ignored.
To assign the 802.1p Default Priority by the RADIUS server, the proper parameters should be
configured on the RADIUS server. The table below shows the parameters for 802.1p default priority.
The parameters of the Vendor-Specific attributes are:
Vendor-Specific Attribute Description Value Usage
Vendor-ID Defines the vendor. 171 (DLINK) Required
Vendor-Type Defines the attribute. 4 Required
Attribute-Specific Field Used to assign the 802.1p
default priority of the port.
0 to 7 Required
If the user has configured the 802.1p priority attribute of the RADIUS server (for example, priority 7) and
802.1X, MAC-based Access Control, JWAC or WAC authentication is successful, the device will assign
the 802.1p default priority (according to the RADIUS server) to the port. However, if the user does not
configure the priority attribute and authenticates successfully, the device will not assign a priority to this
port. If the priority attribute is configured on the RADIUS server is a value out of range (>7), it will not be
set to the device.
To assign the VLAN by the RADIUS server, the proper parameters should be configured on the RADIUS
server. To use VLAN assignment, RFC 3580 defines the following tunnel attributes in RADIUS packets.
The table below shows the parameters for a VLAN:
RADIUS Tunnel Attribute Description Value Usage
Tunnel-Type This attribute indicates the
tunneling protocol(s) to be
used (in the case of a tunnel
initiator) or the tunneling
protocol in use (in the case
of a tunnel terminator).
13 (VLAN) Required
Tunnel-Medium-Type This attribute indicates the
transport medium being
used.
6 (802) Required
Tunnel-Private-Group-ID This attribute indicates group
ID for a particular tunneled
session.
A string (VID) Required
A summary of the Tunnel-Private-Group-ID Attribute format is shown below.
0 1 2 3
0 1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0 1
+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+
| Type | Length | Tag | String...
+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+